manualshive.com logo in svg

Di-Acro QUIK-LOK, Setup And Adjustment

Share
Download
Di-Acro QUIK-LOK Setup And Adjustment Download Page 1

 

 

 

SET-UP AND ADJUSTMENT OF THE DI-ACRO QUIK-LOK 

 

 
 

In order to provide sufficient clamping pressure for bending with a Quik-Lok, it must be set up 

properly. Failure to follow these instructions may result in poor performance from your Di-Acro 
bender. 
 
NOTE: Read the entire procedure prior to setting up the Quik-Lok. A Model 2 bender is shown 
throughout this procedure. All other Quik-Lok assemblies will be set up in the same manner. 
 

1.  Place the desired radius collar on your bender, and mount the Quik-Lok assembly so that the 

clamp block is parallel with the flat side of the radius collar, as shown in Figure 1, below. Leave 
the bolts slightly loose for now.  

 

Figure 1: Proper Quik-Lok placement 

 

 

Summary of Contents for QUIK-LOK

Page 1: ...der NOTE Read the entire procedure prior to setting up the Quik Lok A Model 2 bender is shown throughout this procedure All other Quik Lok assemblies will be set up in the same manner 1 Place the desired radius collar on your bender and mount the Quik Lok assembly so that the clamp block is parallel with the flat side of the radius collar as shown in Figure 1 below Leave the bolts slightly loose f...

Page 2: ...2 With the Clamp Block that corresponds to the radius collar installed onto the Quik Lok Index the handle rod forward as shown in Figure 2 Figure 2 Handle Rod in the Forward or Clamped position ...

Page 3: ...e this position Tighten the knurl head screw until it becomes hard to turn Tighten the bolts for the Quik Lok base and the hold down bolt in the hanger at this time Figure 3 Clamping pressure adjustment The Quik Lok is now adjusted properly for Di Acro tooling Unclamp the Quik Lok by indexing the Handle Rod away from the bender Now adjust the forming nose or roller and start bending Di Acro 12430 ...

Reviews:

No comments

Brands by name

Popular brands

Load more brands