Adesys bv, Wateringen, NL
Operation instructions
Octalarm-T2 / T4 / T8 / T16
15
7. SET CALL NUMBERS
Pressing the Prog-key for a short time will start the set up of the call numbers. The general report
program will be closed (all LED’s switched off) and the Octalarm will guide you by asking some
questions.
Up to 10 call numbers can be set. Each call number is assigned to a letter (A through J) and has its
own reset procedure. Defining all numbers is not necessary. Numbers which have not been set will be
skipped automatically.
A call number can be set as follows:
B
Press the Prog-key for a short time. On the display appears:
A:REPORT TO.................
B
If desired, select an alternative call number (A-J) using
E
or
F
.
B
Press the Prog-key for a short time in order to confirm the selected number.
B
Using
E
or
F
,
select which telephone connected to the telephone network, will receive the report
and confirm this using the Prog-key. You can choose from the following options:
•
report to a telephone. (see paragraph 4.3.1 Report to telephone)
•
report to a pager. (see paragraph 4.3.2 Report to pager)
•
report to a mobile telephone. (see paragraph 4.3.3 Report to mobile telephone)
•
report to a reporting service. (see paragraph 4.3.4 Report to reporting services)
A number can be erased completely by selecting
(NOT DEFINED)
Confirm each new or altered setting by pressing the Prog-key repeatedly, until the message
SETTINGS STORED
appears on the display. Quitting the set-up program during configuration by
using the esc-key, will restore all previous settings!
After erasing the only call number set for a particular alarm, it is no longer possible to report this
alarm by telephone. Therefore, first refer to "dialler" on the list of settings made up by the installer
(see “
Fout! Verwijzingsbron niet gevonden.
") before erasing any number.
7.1 Report to a telephone
B
The Octalarm asks for the number to be dialled. Use
C
or
D
to move the cursor to the field for
setting or changing a digit. Now you can enter the digit using the
E
and
F
key. The following
characters may be used for settings as well:
•
-
: setting a delay for a dialling tone (e.g. if the Octalarm is connected to a home exchange,
requiring a pause after dialling 0 in order to wait for the dialling tone of the outside line).
•
,
: indicates a 2 seconds delay during the dialling and can for example be used if one has to
wait for an undefined dialling tone.
•
!
: used in combination with the
C
and
D
keys to insert or delete digits at the position of the
cursor.
B
Confirm the entered number using the Prog-key.
B
Select the desired reset procedure. See paragraph 7.5 “Set reset procedure”.
