Ochsner AIR BASIC 109, Operating Manual/Installation Manual

Page: 37 / 92

BA_AIR_BASIC_ELW_Multitower_OTE3_SW5x_CC_EN_V08.docx Page 37 of 92
Figure 46: Assembling the appliance sections 1
1 Grip rail
2 Guide pin
3 dotted line (perforation in the metal plate)
4 Guide groove
5 Positioning aid
Figure 47: Positioning aid
1 dotted line (perforation in the metal plate)
- Place the top appliance section onto the
bottom appliance section at the dotted
line.
Figure 48: Assembling the appliance sections 2
- Slide the top appliance section towards
the rear until it is flush with the bottom
section. When the appliance sections are
assembled correctly, the end position is
given by the guide groove and the guide
pin.
- Fasten the tabs at the front of the
appliance.
-
Fit the thermal insulation element and
the 4 hydraulic hoses.
-
Fit the plug-in connectors of the 4
hydraulic connections. Ensure that the
spring clips engage.
- Plug in the sensor on the buffer tank.
-
Route the sensor cable in the guiding
groove in the thermal insulation element.