Ochsner AIR BASIC 109, Operating Manual/Installation Manual

Page: 47 / 92

BA_AIR_BASIC_ELW_Multitower_OTE3_SW5x_CC_EN_V08.docx Page 47 of 92
Step 2 of 3
Flare the pipe ends. The pipe ends must be
deburred before flaring!
Step 3 of 3
Push on the flared pipes (C) and screw on.
Figure 59: Connecting the flared fitting
5.2 Indoor unit connections
CAUTION
The refrigeration connections are located on the
top of the indoor unit. Customer service will solder
them in this location during commissioning. Do
not bend these pipes. Bend the pipes coming from
the outdoor unit for connection.
Figure 60: View of indoor unit Golf Midi
Soldering is performed by customer service during
commissioning.
Fit heat-proof and vapour diffusion-proof
insulation to the refrigerant lines.
5.3 Leakage test
OCHSNER customer service will perform and
record the leakage test during commissioning.
A
B
C
NOTE
Figure 61: View of T200 indoor unit