Ochsner AIR BASIC 109, Operating Manual/Installation Manual

Page: 14 / 92

BA_AIR_BASIC_ELW_Multitower_OTE3_SW5x_CC_EN_V08.docx Page 14 of 92
3.5 Wall bracket for wall mounting
NOTE
Observe the minimum clearances in
section 3.3.1.
Ensure that the mounting feet of the
outdoor unit are at least 300 mm clear
of the surrounding terrain. Take the
expected snow depth at the installation site into
consideration.
The outdoor units can be wall mounted using a
wall bracket.
The wall bracket consists of:
- 2 x wall bracket 600
- 4 x M10 threaded plate
-
4 x M10 washers
-
4 x M10 nuts
-
4 x rubber/metal buffers (A 40/30 M10) for
sound insulation
3.5.1 Requirements for wall mounting
Figure 11: Wall bracket dimensions
L = 600 mm, H = 340 mm
Material S235JR (RST 37-2), galvanised, zinc
coating min. 50 µm
Load bearing capacity
:
F1 = 2.55 kN
Connection forces:
FZ = 7.95 kN
FQ = 4.00 kN
Weight [kg]
AIR BASIC 109 38
AIR BASIC 211 66
AIR BASIC 416 130
AIR BASIC 618 130
3.5.2 Installing the wall bracket
CAUTION
The wall bracket must only be used for
installing the outdoor unit.
CAUTION
Before securing the wall bracket, ensure
that the wall has been tested according
to the specified loads for the respective
outdoor unit. The applicable engineering
standards must be observed.
NOTE
Ensure that the heat pump outdoor unit
is
accessible for service and
maintenance work throughout the year.