Ochsner AIR BASIC 109, Operating Manual/Installation Manual

Page: 32 / 92

BA_AIR_BASIC_ELW_Multitower_OTE3_SW5x_CC_EN_V08.docx Page 32 of 92
4.2.2 Main components
1 Magnesium anode
2 Air vent valve (MFA)
3 Electric booster heater 8.8 kW (MFA)
4 Safety valve (MFA)
5 3-way switching valve (MFA)
6 Electrical connection
7 Cable entries
8 Maintenance flange
9 Drain stopcock
10 Buffer tank (100 l)
11 Drain stopcock
12 Heating circuit pump
13 Buffer charging pump
14 DHW tank (168 l)
15 Condenser (plate heat exchanger)
16 High limit safety cut-out (MFA)
17 Air vent valve
Figure 34: Main components in T200 indoor unit
4.2.3 Installation
4.2.3.1 Installation location
CAUTION
Do not install the appliance in damp
rooms!
Install the appliance in a frost free and dry room
near the draw-off point. In order to reduce line
losses, keep the distance between appliance and
heat pump small.
Ensure that the floor has adequate load bearing
capacity and is sufficiently level (for weight, see
section "Specification / Data table"). The room
must not be endangered by explosive dust, gases
or vapours.
If installing the appliance in a boiler room with
other heating appliances, ensure that their
operation is not affected.
Minimum clearances: