How to Connect a C-Nav3050 to C-Setup /
C-Monitor / C-Scape.
Revision 3
Page 30 of 42
5/5/2017
In the above example the IP address is 10.6.1.189, which is in the same range
as the receiver so a connection should be viable. This will need to be entered
into the Virtua Ethernet Ports menu to facilitate a two way connection.
1.
Select ETH1 and click ‘Configure Port’
Please note
:
If the port is already enabled i.e. set to ‘YES’, toggle this to ‘NO’ and press OK
and re-
enter the ‘Configure Port’ menu to make changes. The port enabled
setting must be toggled to ‘NO’ between changes, and then re-enabled by
setting back to
‘YES’.
