How to Connect a C-Nav3050 to C-Setup /
C-Monitor / C-Scape.
Revision 3
Page 27 of 42
5/5/2017
4.
Once the receiver’s power has been cycled navigate to the following menu
in C-Setup / C-Monitor:
[Device/Ethernet Configuration]
and confirm that the receiver has been assigned an IP address.
In the example below the receiver has been assigned the IP
10.6.1.215,
255.255.255.0.
Thus it can talk to any device in the IP range 10.6.1.XXX.
5. Once an automatic IP address for the C-Nav3050® has been established
use this IP information to set it back to a static type IP address by
selecting “
Manual
”
under DHCP Mode. The IP address could also be
specified to another IP address in the correct range, this is only
recommended for advanced users.
Please note
:
If the C-Nav3050® has previously been configured with a static IP address in
manual mode it will be required to cycle the power on the receiver for it to be
assigned an automatic IP address by the network.
