Oce CS9360, User Manual

Page: 12 / 146

CS9360 User’s Guide
1-12
When cleaning the cleaning wiper
•do not touch the cleaning wiper and head cap unit. Head cleaning may not be performed correctly because of oil
from your hands.
•Make sure to wipe the print head using the cleaning stick. A wet cleaning stick may cause the print head to clog.
•Do not reuse the cleaning stick. The attached dust, etc may damage the print head.
When cleaning around the print head,
•do not touch the nozzles of the print head.
Doing so may damage the print head.
•Do not touch the tip of the cleaning stick.
The print head may be damaged because of oil from your hands.
•Never put water, etc on the tip of the cleaning stick.
Doing so may damage the print head.
•Do not reuse the cleaning stick.
The attached dust, etc may damage the print head.
Do not slant the printer, prop it against a wall or turn it upside down.
There is a possibility that ink inside the printer may leak.
Moreover, normal operation after shifting (to these positions) cannot be guaranteed.
Unpacking or moving this printer must be done by the following number of people.
•CS9360: more than four persons
Installing the dedicated stands on the printer must be done by the following number of people.
•CS9360: more than four persons
When installing the dedicated stands, make sure to switch OFF the printer and unplug the power cable.
There may be a risk of electric shock.
When taking the printer out of the container box, make sure to remove the vinyl and hold the handles on the sides
of the printer.
If lifting up the printer with the vinyl on, there is a possibility the printer can slip out of your hands and drop, and
be damaged.
When you do not use the printer for a long period, make sure to pull out the power plug from the power socket for
safety.
Make sure to connect an earth wire to the earth connection that meets the following standards.
•Earth terminal of power socket
•Earth wire with copper plate which is buried at 650 mm or more, deep in the ground.
Before operation, make sure to read the Material Safety Data Sheet (MSDS).
Ventilate the workplace.
Not doing so may make you feel sick or may lead to a fire.
Right after printing, the media guide becomes very hot.
Allow the media guide to cool down before the next operation.
Pay attention to the following points when cutting roll media.
Mishandling the razor blade may cause a cut on your finger or hand.
•When you hold media, do not place your finger on the media cut groove.
•Move the razor blade along the media cut groove.
When cleaning the areas other than the wiper, make sure to switch OFF the power and unplug the power cable.
Move the printer maintaining a horizontal position.