Oce Arizona 180 GL, User Manual

Page: 122 / 268

5.
Tape the pointed end of the media to the take-up core as shown below.
[82] Tape media to core
6.
Remove the tape you used to hold the media to the platen.
7.
Select the "Initialize" icon from the Roll Media Manager to prepare the RMO for printing.
8.
After initialization has completed, advance the media until the cut area is wound onto
the core across the width of the roll and verify with the ruler that the supply and take-up
edges are at the same location.
Note:
Important: Use the supplied ruler to check that the edge of the take-up roll is aligned
within 1mm of the feed roll.
9.
Start an RMO print job and verify image quality and that there are no wrinkles or
banding.
Chapter 7 - How to Operate the Roll Media Option 122
How to Load Media