PART 2 - REMOVING THE OLD AND REATTACHING THE NEW DRIVE STRAPS
Disconnect the current drive strap from the machine at the oar handle by undoing the locking bolt
concealed by the rubber cover using a 5mm Allen key and at the drive spool pulley by undoing the grub
screw that locks the drive strap clamping pin using an 3mm Allen key.
Attach the replacement drive strap at the oar end first while paying attention to the orientation of the
rubber cover in relation to the oar tube end and the drive strap.
Once attached to the oar, thread the drive strap into the drive arm around the outside of the pulley at the
end of the drive arm. Insert the drive strap into the arm until the open end protrudes from the frame end
of the drive arm.
Visually check by looking inside down the drive arm and remove any twist from the drive strap. Hold the
drive strap in the right position to maintain zero twist in the strap and move the drive strap through the
fingers until holding the open end with about 5cm (2”) of strap extra at the end.
MAINTENANCE
Summary of Contents for Rowing Simulator
Page 1: ...OPERATION MANUAL...
