MAINTENANCE
REPLACING THE DRIVE STRAPS
If it becomes necessary to replace the drive strap webbing due to he drive strap becoming worn
or frayed please follow the procedure set out below.
PART 1 - DISCONNECTING THE RETURN SYSTEM
Fold one or both of the drive arms to aid in the removal of the faring.
Undo the 2 nuts at the front top of the faring holding the faring in place. Lift the faring off the machine
and put it in a safe place while working on the machine.
Release the tension on the return strap by loosening the lock nut for the return strap tensioner under-
neath the frame plate, and then remove the return strap webbing from the tensioner.
Undo the nut at the outer underneath end of the drive arm and the nut inside the open frame end of the
drive arm to release the return bungy rigging frame.
Remove the return bungy rigging frame from the drive arm and put in a safe place away from the working
repair zone of the machine.
Check the condition of the return strap webbing. If still in good condition it can remain attached to the
drive spool pulley. If needing replacing, remove the return strap webbing from the spool pulley at this time
using a 3mm Allen key to loosen the grub screw that locks the return strap clamping pin.
Summary of Contents for Rowing Simulator
Page 1: ...OPERATION MANUAL...
