Operating Instruction and Documentation
4.80 H SST- 4.300 H SST
- 43 -
4.4
Reset of the measuring systems
Over this function, the entire measuring-system of the lift can be put back, (zero). This
function is allowed to only after consultation with the service-headquarters of the Fa.
Nussbaum (phone) + 49 (0)7853-899-0.
Alert message, whether axes should really become reset.
With confirmation of the retrieval with < #> is put down the axes on zero and is jumped
back automatically to the position-ad (2) afterwards.
That zeros of the axes is only possible, if the dip-switch 5 on the „Achscontroller“ stands
on „ON “.
! The installation can become destroyed.
Function button:
< * > Abortion and return into the service-menu (4.2)
< #> axes becomes on zero favored
4.5 Altitudes restricts
The maximum lifting of the lift can be restricted over the menu-point " HUBHOEHE ".
The indicated value can over the button < l > increment and over the button < 0 >
decrement becomes. After election of the desired lift, becomes over < #> the value taken
on. The submenu was deserted.
The submenu was deserted with the button and the changed value was not stored.
Function button:
< * > Demolition and return into the service-menu without stores
< #> store the new value and return into the service-menu
< l > Increases the lifting height
< 0 > Reduces the lifting height
4.6 going back
From a submenu, one can come back into the paramount menu again. Press the button
"ZURÜCK".
Achse nullen?
Summary of Contents for 4.120 H SST
Page 9: ...Operating Instruction and Documentation 4 80 H SST 4 300 H SST 9 2 5 CE Certificate ...
Page 10: ...Operating Instruction and Documentation 4 80 H SST 4 300 H SST 10 ...
Page 13: ...Operating Instruction and Documentation 4 80 H SST 4 300 H SST 13 3 3 Data sheet ...
Page 44: ...Operating Instruction and Documentation 4 80 H SST 4 300 H SST 44 Hydraulic diagram drawing ...
