Nussbaum 4.120 H SST, Operating Instruction And Documentation

Page: 26 / 62

Operating Instruction and Documentation
4.80 H SST- 4.300 H SST
- 26 -
chosen according to picture 9. If the ground is covered with floor tiles, the dowels
have to be chosen according to picture 10.
• Check the position of the columns again. If there is an uneven floor even it with
metal sheets. A continuous contact between the floor and the base plate must be
guaranteed to avoid hollow spaces.
• Tighten the dowels with the dynamometric key (example Liebig-dowels M = 50Nm,
(read the documentation of the dowel manufacturer)
• Fill in the hydraulic-oil approx. 20 litre per column.
• Connect the power supply.
• Press the button „lifting“.
• Check the hydraulic tubes of tightness.
• Remove the erection trestles.
• Lower the lift in the lowest position.
• If necessary create an reset (see chapter 6.3)
• Press the button „lifting“.
• Adjust the sliding guidance at the crossbeam (approx. 4-5 mm movement between
the sliding guidance and the column).
• Mount the cover
• Raise and lower the lift several times with load. Check the torque of the dowels and
check the hydraulic parts for tightness.
9.3 Adjusting the rail
The standard measure between the rails is 1000 mm. It is possible to adjust the rails
+/-200 mm (see the datasheet).
• Lower the lift in the lowest position.
• Drive the vehicle from the lift.
• Loose the screws at the runways and adjust it.
• Tighten the screw.
• The lift has the normal function.
9.4 Changing the installation place
If the place of installation shall be changed, the new place has to be prepared in
according to the regulations of the first installation. The changing should be performed
in accordance with the following points:
• Lower the lift in the lowest position.
• Drive the vehicle from the lift.
• Remove the cover of the operating unit.
• Press the button „lifting“ to raise the lift on a working height
• Lower the lift on the erection trestles..