Operating Instruction and Documentation
4.80 H SST- 4.300 H SST
- 20 -
Pic 7:
The piston rod can be stuck through the dirty
deposit at the top of the hole. Use the solvent and
lubricating stuff (for an example WD40) to
loosen the connection. The WD40 is sprayed
generously between the screw thread and the
bore hole (see arrow). The time of the effect
follows the contamination-degree.
Pic 8:
Loosen the cap of the Minimess connection and the
cap of the tank. Fasten the Minimess hydraulic tube
at the screw fitting and put the other end into the
tank.
Pic 9:
Use the long screw thread-bushing and
turns with a suitable tool (key-wideness 24,
available with your dealer,), clockwise.
Lower the lifting carriage only approx. 5cm
– 10 cm. Repeat the process at the next
column. Lower always 5 cm-10 cm until all
lift are in the lowest position.
Repair the defective lift. After it create a
Reset which is described in the operating
instruction.
Attention!! Lower the automotive-lift only approx. 5cm – 10 cm.
Observe the complete emergency lowering process.
Do not work with the lift until the defective parts are changed.
Summary of Contents for 4.120 H SST
Page 9: ...Operating Instruction and Documentation 4 80 H SST 4 300 H SST 9 2 5 CE Certificate ...
Page 10: ...Operating Instruction and Documentation 4 80 H SST 4 300 H SST 10 ...
Page 13: ...Operating Instruction and Documentation 4 80 H SST 4 300 H SST 13 3 3 Data sheet ...
Page 44: ...Operating Instruction and Documentation 4 80 H SST 4 300 H SST 44 Hydraulic diagram drawing ...
