Section 6
Installation
Cocoon Aqua IR Hydration Pro System
13
5.) Reconnect the wires shown in Picture 5.
6)
The wires that were reconnected in Steps 4 and 5 have to be attached to the
aluminum frame via wire ties. Notice 5 black marks on the aluminum frame
–
these marks indicate the position where wire ties need to be installed to attach the
wires to the aluminum frame. Snip the excess plastic off the wire tie after
tightening to the aluminum frame.
6.3 Adjusting the Legs
This unit must be installed on an even, dry surface and levelled
by adjusting the unit legs.
Loosen nut 2.
Regulate height by adjusting nut 3 (nut 1 must be held while
adjusting).
If the position is correct, tighten nut 2.
If unable to hold nut 1 with a wrench, use a wedge (example
screwdriver).
