SPLITMUX
- Installation and Operation Manual
ON SCREEN DISPLAY
28
CONTROL
Navigate with the arrow keys in the SYSTEM menu to the entry CONTROL
Press ENTER/SELECT to open the CONTROL window.
SPLITMUX
can be controlled via DCP (Device Control Protocol), an XML-based protocol (see Annex).
There are two DCP modes:
DCP control
,
which allows external control of the display mode.
DCP synchronize
,
which keeps several
SPLITMUX's
in the same display mode.
Default setting is “off”, which prevents any external CONTROL.
Use a serial or USB cable to connect a control unit to the RS 232 port (RJ 45) on the
SPLITMUX
rear
panel. To synchronize several devices, special Y cables are required.
Settings for the connection are: Transfer rate 57600 baud, 8 data bits, no parity, 1 stop bit, no flow control
The two control modes operate as follows:
OSD - SYSTEM - CONTROL
DCP control
This mode allows direct control of a single
SPLITMUX
by means of a control device, e.g. a
computer.
The control device can query and change the
mode of
SPLITMUX
.
SPLITMUX
responds to each DCP message
sent by the control device with a DCP reply.
This reply includes the values of all settings queried
or set by means of the last message. If the message
sent by the control unit contains errors, the
SPLITMUX
will reply by sending an error message.
Summary of Contents for SPLITMUX-DVI-4RT
Page 52: ......
Page 89: ...SPLITMUX Installation and Operation Manual ANNEX 84 DECLARATION OF CONFORMITY...
Page 109: ......
