NT-ware uniFLOW Release Station, Configuration Manual

Page: 21 / 56

uniFLOW Release Station
7

If no DHCP is available, the uniFLOW Release Station obtains an IP address from
the link-local block (for IPv4 169.254.0.0/16, for IPv6 the fe80::/10 prefix). You can
use this IP address to access the uniFLOW Release Station website and assign the
correct IP address manually.

uniFLOW Release Station does not support IPv6 at the moment. IPv6 can only be
used for a temporary link-local address for configuration purposes. Any further use
of IPv6 is not supported.

Please make sure to attach the network cable to the uniFLOW Release Station
before switching it on.
1.
After the uniFLOW Release Station has been successfully connected to the
network of the uniFLOW server, it will display its assigned IP address:
2.
The uniFLOW Release Station has now to be assigned to a Secure Print - Output
Printer in uniFLOW. To do so, the
Secure Print - Output Printer with uniFLOW
Release Station printer wizard has to be used:
a. Go to uniFLOW Server Configuration > Printer/ Scanner > Wizard.
b. Select the Secure Print - Output Printer with uniFLOW Release Station .
c. Follow the steps of the wizard. Make sure to have IP addresses of the Release
Station and the printer at hand.
3.
After the uniFLOW Release Station has been successfully configured in uniFLOW, it
will display the login screen of the login method you chose during the wizard.
The uniFLOW Release Station is now ready to use.

The uniFLOW Release Station does not require any separate license to be
purchased in order to work with uniFLOW and RPS.

The uniFLOW Release Station uses TCP port 8000 for discovery and EAI
communication with uniFLOW. Make sure this port is open in both directions if
you have any connection problems.