NT-ware uniFLOW Release Station, Configuration Manual

Page: 18 / 56

uniFLOW Release Station
4
5 LED / Beep Status
The uniFLOW Release Station is equipped with either three, one or no LEDs, depending
on what model is used.
uniFLOW Release Station Hitag/HID/Multi
The uniFLOW Release Station Hitag/HID/Multi is equipped with 3 status LEDs: green
(left), yellow (middle) and red (right). The table below shows the status information
given by the respective LED.
Status Green LED Yellow LED Red LED
Booting up flashing flashing
Not synchronized flashing
Synchronized (operating) flashing
Authentication OK on flashing
Authentication failed flashing on
The uniFLOW Release Station Hitag/HID/Multi is equipped with a little beeper which
emits different beep tones for different statuses. The table below shows the status
information given by the beeper.
Status Beep Signal
The card reader is booting up. 2 x fast
The card reader is not parameterized which means, there
was no saved config found.
2 x slow
The card reader is parameterized. A configuration was found
on the device.
1 x short
If parameters are sent to the card reader. 2 x slow
A card has been detected. 1 x long
If a Facility Code has been detected as invalid. 3 x fast
uniFLOW Release Station PLUS / PLUS-2 V2
The uniFLOW Release Station PLUS / PLUS-2 V2 is equipped with 1 status LED that can
show three colors: Green, Yellow and Red. The table below shows the status
information given by the LED.