NovaScale r410 e1, User Manual, Page: 88 / 325

User Guide
88
www.bull.com
11. Repeat steps 5 through 10 for the right slide rail, ensuring that it is parallel and
level with the left slide rail.
12. If you wish to install a cable arm, follow the instructions in “Installing a Cable
Arm (with Sliding Rails Only)” on page 89 before going to step 13
13. Extend both slide rails into the fully extended (locked) position.
14. Align the mounting studs with the component mounting channels on the slide
rails.
15. Carefully place the component mounting studs in the component mounting
channels on the slide rails.
Allow the component mounting studs to fully seat in the component mounting
channels (letter “D” on Figure 46). The component release levers (one on each
slide rails) pivot out of the way and then back in place whent the studs are fully
engaged in the mounting channels.
Ensure that the component release levers are in locked position.
Figure 54: Placing the System on the Rails
A: Mounting studs
B: Slide extension release lever
C: Component release lever
16. Use two rack screws (#10-32 x 3/4) to secure the chassis and rack handles into
the rack.
17. Press and hold the left and right slide extension release levers and slowly slide
the component and side rails into the fully retracted position.