NovaScale r410 e1, User Manual, Page: 164 / 325

User Guide
164
www.bull.com
Installing or Removing a 5.25-inch Device
This section of the chapter describes how to add and remove 5.25-inch devices. You
can install an optical disc drive, tape backup unit, or other 5.25-inch devices in the
additional 5.25-inch bay.
Note: Additional power and/or data cables may be included
with your system. In this case, store them in a safe place, you
will need them if you decide to add additional drives.
Installing a Slimline Optical Device
1. Make sure the power switches for the computer, video monitor and any
peripheral devices are turned OFF and unplug the power cord (see “General
Safety Information” on page 132 ).
2. Disconnect the monitor and peripheral devices (printers, for instance) from the
system.
3. Remove the server cover. Refer to “Removing the Server Cover” on page 160 .
4. Remove the bezel if it is installed. Refer to “Removing the Front Bezel” on
page 158 .
5. Note the orientation of the PCI cooling fan that is located behind the optical
drive bay, then lift the fan (letter “B”) from the mounting pegs. It is not
necessary to disconnect the fan cable (letter “A”).
Figure 108: Lifting the PCI Cooling Fan from the Mounting Pegs
A
B