NovaScale r410 e1, User Manual, Page: 110 / 325

User Guide
110
www.bull.com
Hot-Swapping a Power Module
Warning
Hazardous voltage, current, and energy levels are present
inside the power supply. There are no user-serviceable parts
inside it; servicing of the power supply should be done only by
technically qualified personnel.
1. Observe the safety and ESD precautions listed in “General Safety
Information” on page 132 .
2. Remove the power cable from the defective power supply.
Warning
Put on protective gloves before you follow the instructions
below. The power modules are very hot and there is a risk of
severe burns.
3. Press up on the green latch (A) while pulling on the handle (B) to remove the
hot-swap power supply from the chassis.
Figure 77: Removing the Hot Swap Power Supply Module from the Chassis
4. Insert the new hot swap power supply module.
Figure 78: Inserting Hot Swap Power Supply Module in Chassis
5. Connect the power cable to the replaced hot swap power supply.
TP00856
A
B
TP00854