
3 - INSTALLATION
3-23
21. Lay a straight edge across the pulley faces to check the
alignment. Tighten the hub bolts to secure pulley on the
drive shaft. Allow for 1/4" to 3/8" of clearance between
the inside sheave face and shield back.
1/4”
to
3/8”
Fig. # 3-58 Align Sheave Faces
22. After alignment is established, tighten the sheave bolts
to secure to the shafts.
23. Push on the center of the belt span with a force of ap
-
24. The belts will deflect approximately 1.00” (25 mm) when
properly tensioned.
5 lbs
(2.26 kg)
Of Force
1.00"
(25mm)
Fig. # 3-59 Proper Belt Deflection
25. Adjust the
"Motor Mount Belt Tension Lever"
57
to
26. Close and secure the drive belt guard.
27. When the Power Sweep is not in use, reduce the belt
tension by lowering the
"Motor Mount Belt Tension
Lever"
57
.
Summary of Contents for The Grain Handler 10
