Norwood The Grain Handler 10, Operator'S Manual, Page: 59 / 130

3 - INSTALLATION
3-19
6. Connect the "Horizontal Powerhead Output Shaft" 44
to the input shaft of the "U-Trough Unloading Auger
Flighting"
42
with the (Qty. 2) "1/2-13 X 3 Bolts" 45 ,
& "1/2-13 Nuts"
46
.
45
46
46
42
45
Fig. # 3-42 Horizontal Powerhead Installation Step # 6
7. Next, push the "Horizontal Powerhead" 43 with the
connected "U-Trough Unloading Auger Flighting"
42
back into the "U-Trough" 2 . Rotate the powerhead
slightly left to right so that the end of the auger flighting
splines meshes with the gearbox spline. (See Fig. # 3-43)
2
42
43
Fig. # 3-43 Horizontal Powerhead Installation Step # 7
8. When properly set, the end of the "U-Trough Unloading
Auger Flighting"
42
should be approximately 1.00" from
the "Splined Gearbox Input Shaft" 55 .
(See Fig. # 3-44)
Fig. # 3-44 Horizontal Powerhead Installation Step # 8
55
1.00"
42
9. Secure the "Horizontal Powerhead" 43 to the
"U-Trough" 2 with the (Qty. 4) "1/2-13 X 1 Bolts" 3
, & "1/2-13 Nuts"
4
.
(See Fig. # 3-45)
Fig. # 3-45 Horizontal Powerhead Installation Step # 9
2
4 3
43
10. Install the "Powerhead Guard Assembly"
47
with the