5 - MAINTENANCE
5-40
6. Heat the external spindle area with
Propylene (Fg105 or
FG26) Oxygen, (ox200 or ox125) gas
, using a
Smith
ST815 Propylene Heating Tip Assembly - ST815
(Rosebud Equivalent)
Heat the tube until it reaches a
dull red glow.
NOTE
Norwood recommends Propylene (Fg105 or FG26) Oxy
-
gen, (ox200 or ox125) gas mixture for faster heating times.
If this gas mixture is not available, an Oxy-Acetylene mix
is acceptable, but will take longer to heat.
6.00”
Fig. # 5-75 Heat The External Spindle Area
7. Immediately drive the
1” NUT D
with an impact driver,
driving it CW & CCW directions until the stuck hub is free.
Fig. # 5-76 Drive The Nut With An Impact Driver
8. In addition, you can use a
PRY BAR H
,
to
pry between
the
ROLLER TUBE G
,
and the
SPINDLE, ROLLER
HUB E
to break it free.
G
E
H
Fig. # 5-77 Pry Between The Roller Tube & Hub
Summary of Contents for Kwik-Till HSD2500
