Norwood Kwik-Till HSD2500, Operator'S Manual

Page: 111 / 154

5 - MAINTENANCE
5-19
WEEKLY
Check For Gap At Pivot Bushing Caps
1. Unfold the machine into the Field Position .
(See “Kwik-
Till Folding & Unfolding” on page 4-11)
2. Lower the disks to the ground by retracting the Front
Wheel Cylinders
A
and Rear Roller Cylinders B .
(See Fig. # 5-10)
A
B
Fig. # 5-10 Lower Disks to the Ground
3. Relieve all the hydraulic pressure by placing the tractor
SCV levers to the FLOAT POSITION with engine
running for the Main Frame Lift & Wing Fold cylinders.
4. The machine should now be in the “Field Lowered Po-
sition”
(See Fig. # 3-53)
.
5. Check Pivot Bushing Caps
C
for gaps
E
. (See Fig.
# 5-11)
CHECK FOR GAPS
(SHOULD BE FLUSH)
C
E
Fig. # 5-11 Check For Gaps At Pivot Bushing Caps
6. For Pivot Bushing Cap
C
locations,
(See Fig. # 5-9).
IMPORTANT
Any indication of any Gap
E
between Pivot Bushing
Caps
C
will cause bolt breakage and further machine
damage
could occur due to uncontrolled machine move-
ment
.
7. If any Pivot Bushing Caps
C
have Gaps
E
,
re-torque
the 3/4-10 X 3-3/4 Hex Bolts B to 500 ft-lbs (678 N-m).
(See Fig. # 5-12)
500 ft-lbs
678 N-m
B B
C C
B B
E
E
Fig. # 5-12 Re-Torque All Pivot Bushing Caps With Gaps