Norwood Kwik-Till HSD2500, Operator'S Manual

Page: 90 / 154

4 - WORKING OPERATIONS
4-24
Adjusting Rear Roller Deflector
The following instructions are for adjusting the “Rear Roller
Deflector” for the “Kwik-Till tillage equipment. To start this
process, proceed as follows:
1. Determine the Rear Roller Deflector installed locations.
The Rear Roller Deflectors are installed in these locations.
(See Fig. # 4-69)
2. The Rear Roller Deflector
A
is set at the factory to
the highest position. It is the operator’s responsibility to
adjust to the working depth for the soil conditions.
(See
Fig. # 4-65) (Note: Center and Right Wing is removed to
clarify illustration)
A
Side To Side
Adjustment
Slots
Height
Adjustment
Slot
Fig. # 4-65 Rear Roller Deflector
3. To adjust the Rear Roller Deflector
A
, loosen the ad -
justment bolts, & nuts.
(See Fig. # 4-66)
Loosen
Nuts
Loosen
Bolts
Fig. # 4-66 Loosen Adjustment Bolts & Nuts
4. Adjust to desired position. The Rear Roller Deflector
A
has 20° of vertical adjustment. The Spring Packer
B
has 1.72” of side to side adjustment.
(See Fig. # 4-67)
B
A
Fig. # 4-67 Adjust To Desired Position
NOTE
Setting the Rear Roller Deflector too low can result in a
trench or possibly cause plugging.
Rear Roller Deflector Troubleshooting:
• Adjust Rear Roller Deflector down slightly to remove ridge.
• Adjust Rear Roller Deflector up slightly to eliminate groove.
5. Tighten the bolts, & nuts.
(See Fig. # 4-68)
Tighten
Nuts
Tighten
Bolts
Fig. # 4-68 Tighten Adjustment Bolts
6. Repeat Steps 1-5 for second location of your machine.