Norwood Kwik-Till HSD2500, Operator'S Manual

Page: 104 / 154

5 - MAINTENANCE
5-12
5. Once the gap is set, adjust the 7/16” Set Screws A
against the Adjustable Scraper Ears
B
.
(See Fig. #
5-20)
Fig. # 5-20 Tighten Set Screws
A
B
A
6. Tighten the (Qty 8) 1/2”-13 Nylock Nuts A . (See Fig. #
5-21)
Fig. # 5-21 Tighten Hardware
A
Scraper Blade Replacement & Alignment
The following instructions are for the purpose of replacement
and alignment of the scraper blades of the Kwik-Till tillage
equipment rubber roller option. To start, proceed as follows:
1. Unfold the machine into the Field Position.
(See “Kwik-Till
Folding & Unfolding” on page 4-11)
2. Lower the disks to the ground by retracting the Front
Wheel Cylinders
A
and Rear Roller Cylinders
B
.
(See
Fig. # 5-22)
A
B
Fig. # 5-22 Lower Disks to the Ground
3. Relieve all the hydraulic pressure by placing the tractor
SCV levers to the FLOAT POSITION with engine
running for the Main Frame Lift & Wing Fold cylinders.
(See Fig. # 5-23)
Fig. # 5-23 Tractor Remote Valve Levers Setting SCV To
Float Position