SECTION TWO: Installing and wiring the 6000i
6000i
Installation Manual, Rev. G
Page 9
The interface connectors
Interface connectors are shown in Figure 6: ”Interface connectors,” below. The functions of these
connectors are described in Table 6. Interfacing is described in detail in Section Six, beginning on
page 31.
Table 6: Interface connector functions
Connector name
Connector function(s)
Connects to...
NMEA
(18-pin connector)
NMEA Port 1 input/output
NMEA devices: autopilot, heading
sensor, etc.
NMEA Port 2 input/output
Same as NMEA Port 1, or Northstar
radar
RS-232 Port
SC-104, NMEA devices, or remote
power control
Honk alarm/200 ppnm
Remote honk alarm, or speed
indicator
Ethernet
(RJ-45)
N2 Networking
Another 6000i or other
N2-compatible device (N2 is
Northstar’s proprietary format)
GPS
(TNC coaxial 50 Ohm)
GPS antenna input
AN150-P GPS antenna
POWER
GPS
ANTENNA
FUSE
(7 Amp)
NTSC
VIDEO
INPUT
NMEA
ETHERNET
AUX
VGA
(video out)
6.4" unit shown (all units use same connector layout)
REAR VIEW OF
6000i
Figure 6: Interface connectors
Summary of Contents for 6000i
