NorthStar 6000i, Installation Manual

Page: 12 / 56

SECTION TWO: Installing and wiring the 6000i
Page 8 6000i Installation Manual, Rev. G
Flush-Mounting Template , which you can use to drill the mounting holes and cut the mounting panel
in the exact recommended locations.
Use the supplied flush-mount template to cut the hole for the 6000i , and use the supplied gasket
between the 6000i and the instrument panel to help seal against water penetration. The use of
anti-seize compound on the flush-mount studs and nuts is recommended.
The parts kit contains the appropriate number of threaded studs, flat washers, lock washers, and hex
nuts for flush mounting.
Yoke-mounting
For recommended mounting clearances, see Figures 1 – 3 on the previous pages. Leave additional
clearance for opening the cartridge door on the right side of the unit. The 12- inch and 15-inch
models are designed for flush-mounting only.
When yoke-mounting, the four plastic “poker chips” are inserted into the holes in the unit and the
yoke. It may be helpful to apply a dab of RTV or other adhesive to keep them in place during
installation, especially if the unit will be removed and replaced frequently.
Wiring the
6000i
Avoiding cable wiring shortcuts
Most installation problems are caused by shortcuts taken with system cables. When wiring the
6000i , follow the guidelines below.
CAUTION! When flush mounting, be sure to mount the 6000i on a flat surface.
Mounting on a curved surface can result in water leaks. Do not
overtighten the mounting screws; you may damage the case and
compromise its waterproof seal. This type of physical damage will
void the warranty.
DON’T DO THIS!
•
Don’t make sharp bends in the cables
•
Don’t run cables in a way that allows water
to flow down into the connectors
DO THIS!
•
Do make drip and service loops
•
Do tie-wrap all cables to keep them secure
•
If cables are shortened, lengthened, or
re-terminated, do seal and protect all wiring
connections
•
Do leave room at the back to install and
remove cables