120
Chapter 6 Configuring the Passport 8672ATME Module
209195-B
Basic configuration procedures
This section provides instructions on configuring the Passport 8672ATME
Module with Device Manager to perform basic networking tasks:
•
“Bridging point-to-point traffic using an ATM 1483 PVC using Device
Manager
,” next
•
“Bridging point-to-point traffic using an ATM 1483 PVC using the CLI” on
page 127
•
“Bridging point-to-multipoint traffic using an ATM 1483 PVC using Device
Manager” on page 127
•
“Bridging point-to-multipoint traffic using an ATM 1483 PVC using the CLI”
on page 129
•
“Configuring an IP routing 1483 PVC using Device Manager” on page 129
•
“Configuring an IP routing 1483 PVC using the CLI” on page 136
•
“Configuring an IPX routing 1483 PVC using Device Manager” on page 137
•
“Configuring an IPX routing 1483 PVC using the CLI” on page 143
Bridging point-to-point traffic using an ATM 1483 PVC using
Device Manager
In this configuration
(Figure 50)
, the Passport 8672ATME Module has an ATM
1483 PVC bridged across an ATM PVC network. Use a separate ATM1483 PVC
for each VLAN. The VLANs may appear on the same port or on different ports of
the Passport 8672ATME Modules. You cannot bridge between PVCs in the same
VLAN on the same port of the Passport 8672ATME Module.
Nortel Networks recommends that you create a new STP group for bridging
between ATM ports and Ethernet ports. You should remove the ATM port from the
default STP group and from the default VLAN. This minimizes BPDU traffic to
the ATM port. Passport ports receive BPDU traffic for the default STP group and
the tagged VLAN.
Summary of Contents for Passport 8672ATME
