Nortel Circuit Card, Installation Manual, Page: 92 / 908

Page 92 of 906 Acceptance tests
553-3001-211 Standard 3.00 August 2005
Again, see “LD 38” in the Software Input/Output: Maintenance
(553-3001-511) for detailed information on using this command.
7 End the session in LD 38:
****
End of Procedure
Digitone receiver cards
Procedure 3
Testing digitone receiver cards
Use this procedure to test a Digitone receiver (DTR) card, a DTR
daughterboard, or the DTR function on the NT8D18 Network/DTR card.
Note: The DTR daughterboard connected to a QPC659 Dual Loop
Peripheral Buffer card cannot be assigned when the IPE shelf is used in
single loop mode.
1 Log into the system:
LOGI (password)
2 See if the Digitone receiver to be tested is disabled:
LD 34
STAT
The system responds with the terminal number (TN), or numbers, of any
disabled Digitone receivers.
3 If the Digitone receiver is disabled, enable it:
ENLR l s c u loop, shelf, card, and unit numbers
4 Test the Digitone receiver:
DTR l s c u loop, shelf, card, and unit numbers
If the system response is other than OK , see the Software Input/Output:
Administration (553-3001-311) to analyze the messages.
5 End the session in LD 34:
****
End of Procedure