Nortel Circuit Card, Installation Manual, Page: 224 / 908

Page 224 of 906 NT5D11 and NT5D14 Lineside T1 Interface cards
553-3001-211 Standard 3.00 August 2005
Disconnect supervision
The lineside T1 card supports far-end disconnect supervision by opening the
tip side toward the terminal equipment upon the system's detecting a
disconnect signal from the far-end on an established call. The Supervised
Analog Line feature (SAL) must be configured in LD 10 for each lineside T1
port. At the prompt FTR, respond:
OSP <CR>
and against FTR respond:
ISP <CR>
The lineside T1 card treats OSP and ISP for both originating and terminating
calls as hook flash disconnect supervision, also known as cut-off disconnect.
Originating calls are outgoing from the terminal equipment. Terminating
calls are incoming to the terminal equipment. The lineside T1 card does not
support battery reversal answer and disconnect supervision on originating
calls.
After the software is configured, power up the card and verify the self test
results. The
STATUS LED on the faceplate indicates whether or not the
lineside T1 card has passed its self test, and is functional. When the card is
installed, this LED remains lit for two to five seconds as the self-test runs. If
the self-test completes successfully, the LED flashes three times and remains
lit. When the card is configured and enabled in software, the LED goes out.
The LED goes out if either the motherboard or daughterboard is enabled by
the software. If the LED flashes continuously or remains weakly lit, replace
the card.
Daughterboard 4 21
Daughterboard 5 22
Daughterboard 6 23
Daughterboard 7 24
Table 87
DX-30 to T1 time slot mapping (Part 2 of 2)
Item TN T1 Channel Number