Nortel Circuit Card, Installation Manual, Page: 477 / 908

NT7D16 Data Access card Page 477 of 906
Circuit Card Description and Installation
Autodial (A)
The Autodial command allows the user to dial a predefined number stored
within the local system. The DAC will automatically attempt to place a data
call to the Autodial number:
The currently stored Autodial number may be viewed by entering the primary
command D (Display), followed by the selection A (Autodial). See the
Display discussion later in this document.
Note: If the Autodial feature key is not defined in the software you will
be notified by the following: Feature key Autodial not defined.
Speed Call (S)
The Speed Call command allows the user to make a call to a number
associated with a 1-, 2-, or 3-digit access code. The user supplies the access
code, and the DAC places the call according to the code supplied.
If the DAC does not know the access code length, you will be notified by:
ENTER ACCESS CODE (all digits) <SP>. Leading zeroes must be entered
A <CR>
CALLING xxxxxxx
RINGING
ANSWERED
CALL CONNECTED. SESSION STARTS
S<CR>
ENTER ACCESS CODE: <SP>
xxx<CR>
CALLING yyyyyy
RINGING
ANSWERED
CALL CONNECTED. SESSION STARTS