108
Maintenance Releases
Procedure Steps
Step
Action
1
Load the ServeRAID firmware upgrade CD into the CD-ROM
drive.
2
Log on to the server as the SSA role (ntsysadm).
3
Reboot the server.
4
If the operating system has been installed, change the boot
sequence so that the CD-ROM is the primary boot device by
doing the following:
•
When the BIOS information appears, press F12 to select the
boot sequence.
•
Select CD-ROM as the primary boot device.
Otherwise, wait for the server to reboot.
The ServeRAID Manager screen appears. (This may take up to
two minutes.)
5
If an upgrade is not required, click OK to reboot server and
go to step 9. (The OK prompt does not always display. If this
happens, select File> Exit, and select Restart to reboot the
server.)
Otherwise, select Update to apply the update.
Attention:
Do not power off the system during the update.
The ROM Update Wizard displays a firmware message.
6
Click OK.
7
Click Next to complete the update.
8
Click Finish.
The server reboots.
9
Remove the CD from the CD-ROM drive.
--End--
Application Server 5300
Nortel AS 5300 Installation
NN42040-300
01.04
4 November 2008
Copyright © 2007-2008 Nortel Networks
.
Summary of Contents for Application Server 5300
Page 123: ......
