256
Link Layer Discovery Protocol (802.1ab)
"lldp command parameters and variables" (page 256)
describes the
parameters and variables for the
lldp
command.
lldp command parameters and variables
Parameters and variables
Description
tx-interval <5-32768>
Set the interval between successive
transmission cycles.
tx-hold-multiplier <2-10>
Set the multiplier for the tx-interval used to
compute the Time To Live value for the TTL
TLV.
reinit-delay <1-10>
Set the delay for the reinitialization attempt if
the adminStatus is disabled.
tx-delay <1-8192>
Set the minimum delay between successive
LLDP frame transmissions.
notification-interval <5-3600>
Set the interval between successive
transmissions of LLDP notifications.
lldp port command
The
lldp port
command sets the LLDP port parameters. The syntax for
the
lldp port
command is
lldp port <portlist> [config notification] [status {rxOnly |
txAndRx | txOnly}]
Run the
lldp port
command in Interface Configuration command mode.
"lldp port command parameters and variables" (page 256)
describes the
parameters and variables for the
lldp port
command.
lldp port command parameters and variables
Parameters and variables
Description
port <portlist>
Specify the ports affected by the command.
config notification
Enable notification when new neighbor
information is stored or when existing
information is removed.
status {rxOnly | txAndRx |
txOnly}
Set the LLDPU transmit and receive status on
the ports.
•
rxonly: enables LLDPU receive only
•
txAndRx: enables LLDPU transmit and
receive
•
txOnly: enables LLDPU transmit only
Nortel Ethernet Routing Switch 4500 Series
Overview — System Configuration
NN47205-500
02.01
Standard
5.0
23 February 2007
Copyright © 2007, Nortel Networks
Nortel Networks Confidential
.
