Nortel 252, Configuration

Page: 309 / 345

309
Nortel Business Secure Router 252 Configuration — Advanced
Appendix I
Boot Commands
The BootModule AT commands execute from within the router’s bootup
software, when debug mode is selected before the main router firmware is started.
After you start up your Business Secure Router, you are given a choice to go into
debug mode by pressing a key at the prompt shown in screen shown in
Figure 156 . In debug mode you have access to a series of boot module commands,
for example ATUR (for uploading firmware) and ATLC (for uploading the
configuration file). These are already discussed in
Chapter 15, “Firmware and
configuration file maintenance” on page 179 .
Figure 156 Option to Enter Debug Mode
Enter ATHE to view all available Business Secure Router boot module
commands, as shown in
Figure 157 on page 310 . With ATBAx, you can change
the console port speed. The x denotes the number preceding the colon to give the
console port speed following the colon in the list of numbers that follows; for
example ATBA3 will give a console port speed of 9.6 Kb/s. ATSE displays the
seed that is used to generate a password to turn on the debug flag in the firmware.
Bootbase Version: V1.02 | 08/08/2001 15:40:50
RAM: Size = 16384 Kbytes
DRAM Post: Testing: 16384K OK
FLASH: Intel 16M
RAS Version: V3.50(WB.0)b3 | 08/08/2001 16:21:27
Press any key to enter debug mode within 3 seconds.
.................................................