Norland Elite 437A150, Operator'S Manual

Page: 82 / 490

Preferences: Whole Body Scan
The following figure shows the default Whole Body
1
Scan parameters. The default settings should be effective
for most scanning situations.
Figure 3-8: The default Whole Body Scan Parameters
Note: WHAT TO DO: To restore the
default
Scan parameters, click and
. This will restore the defaults for
all
scan types.
Note: WHAT TO DO: To change the default Scan parameters, access the Scanner Preferences win-
dow from the main Database Navigator window as described next.
If it is not already open, click on Edit > Scanner Preferences > Scanning tab.
Locate the Whole Body scan parameters in the window (shown above).
Select and change any of the scan parameters, such as resolution, scan width, or speed.
Click and at the bottom of the window. These settings now become the
default settings until changed again.
PARAMETER DESCRIPTIONS:
Speed / Resolution: There are 6 possible combinations of speeds and resolutions. They are listed below.
The default setting is
6.5 X 13.0mm @ 260mm/sec
.
1
Whole Body Spine Scan is not available on some models.
Operator's Guide
437D140 Rev. I
3-26 Installation and Setup