Nordson Versa-Spray II, Customer Product Manual

Page: 30 / 64

Repair
6-2
Part 107016-02
E 2016 Nordson Corporation
Powder Path Repair
(contd)
7. Inspect all O-rings and replace them if damaged.
8. Inspect the powder path parts. Replace worn parts as necessary.
9. Reverse the disassembly procedure to assemble the powder path.
1400418B
1
2
3
4
5
6
7
8
Figure 6-1 Powder Path Repair
1. Multiplier
2. Resistor probe
3. Powder inlet body 4. Wear sleeve
5. Optional nozzle adapter
6. Nozzle 7. Set screw
8. Hose adapter
Note: Item 4 is not used on guns that have an optional nozzle adapter.
Multiplier Replacement
The multiplier replacement kit consists of a new multiplier and a resistor
probe with contact tip, filled with dielectric grease and assembled.
See Figure 6-2.
1. Disconnect the gun cable, feed hose, and air tubing (if it is used) from
the spray gun.
2. Loosen the set screws (1) in the gun mount (2). Remove the spray gun
from the mounting bar.
3. Perform steps 1 through 4 of the Powder Path Repair procedure.