Nordson Encore HD iControl 2, Installation, Troubleshooting, Repair

Page: 76 / 114

© 2022 Nordson Corporation
1609758-04
4-26 Troubleshooting
Error
Code
Message Correction
2107
Speed calculated less
than minimum
Default or preset settings for variable mode resulting in speed less than
minimum.
Minimum speed is 15 ft/min. Change default or preset settings. Part may be
too small to use variable mode, change to a fixed mode.
2108
Speed calculated greater
than maximum
Default or preset settings for variable mode or fixed with conveyor
synchronization resulting in speed faster than maximum.
Change the default or preset settings or reduce the conveyor speed.
1112
Positioner not in ready
state for color change
In/out positioner not in Manual or Auto mode.
Color change cycle cannot start unless in/out positioner is in Manual or Auto
mode. Set in/out positioner mode to Manual or Auto.
2113
Reciprocator not in ready
state for color change
Reciprocator not in Auto mode.
Color change cycle cannot start unless reciprocator is in Auto mode. Set
reciprocator mode to Auto.
3200
Reciprocator Watchdog
fault
The reciprocator controller did not respond with a watchdog signal in 1 second.
Check the Ethernet cable connections and the reciprocator controller.
Other Reciprocator Troubleshooting
Table 4-9 Other Reciprocator Troubleshooting
Problem Cause Correction
No movement from
reciprocator in response
to move command
A fault has occurred
preventing operation.
Check the iControl 2 alarm log.
Identify the fault and review the fault troubleshooting information
in this table.
Configuration lockout
applied to reciprocator.
Check the Reciprocator control screen for the lockout indicator.
Lockout is applied from the Configuration screens.
iControl 2 lockout
applied to spray guns,
in/out positioners, and
reciprocators.
This is a normal condition unless a failure has occurred. Refer to
Photoeye, Encoder, and Interlock Troubleshooting in this section.
Continued...