Nordson Encore HD iControl 2, Installation, Troubleshooting, Repair

Page: 46 / 114

© 2022 Nordson Corporation
1609758-04
3-22 Installation
Program and User Data Cards
The iControl 2 program and user configuration and preset data are stored on two 128 Mb
or larger CompactFlash (CF) cards. These cards function as removable hard drives. The
iControl 2 consoles are shipped with these cards installed.
NOTE: The Rev 2 Arbor PC requires a minimum of a 2 Gb CompactFlash.
CAUTION: The CompactFlash cards CANNOT be hot-swapped. Shut down the iControl
2 program and operating system, then turn off the iControl 2 console before removing
the cards. Removing the cards while power is on could corrupt the data on the cards and
damage the cards.
CAUTION: Never turn off console power without first shutting down the iControl 2
program and operating system. Doing so could corrupt the system software. Refer to
Program Shutdown in the iControl Operator Interface
manual for the shutdown
procedure.
The CompactFlash card slots are on the side on the PC. The Program card must be
installed in Slot 1, and the Data card is installed in Slot 2.
The iControl 2 program can be updated by installing a new program card.
NOTE: To remove a card, press on the eject button, then pull the card out of the slot.
Serial (Touch Screen)
ETH1
(Ethernet)
ETH0
(Ethernet)
24 Vdc Power
SLOT1 − Program
SLOT2 − Data
VGA (Touch Screen)
CAN Network
I/O Ribbon Cable
Connection
Figure 3-12 iControl 2 Program and User Data Card Slots