Nordson Encore HD iControl 2, Installation, Troubleshooting, Repair

Page: 69 / 114

© 2022 Nordson Corporation
1609758-04
4-19 Troubleshooting
Other In/Out Positioner Troubleshooting
Table 4-7 Other In/Out Positioner Troubleshooting
Problem Possible Cause Corrective Action
No movement from in/out
positioner in response to
move command
A fault has occurred
preventing operation.
Check the iControl 2 alarm log.
Identify the fault and review the fault troubleshooting information
in this table.
Configuration lockout
applied to in/out
positioner.
Check the In/Out Positioner control screen for the lockout
indicator. Lockout is applied from the Configuration screens.
iControl 2 lockout
applied to spray guns,
in/out positioners, and
reciprocators.
This is a normal condition unless a failure has occurred. Refer to
Photoeye, Encoder, and Interlock Troubleshooting
in this section.
Remote disable applied
to in/out positioner
controller. No status
display on iControl 2
screens.
If Nordson USA ColorMax system:
Disable action is applied by a remote system control panel
keyswitch. In the Disable position, the keyswitch opens the
disable input circuit at the in/out positioner controller.
No corrective action is required unless the keyswitch Normal
position does not allow motion. Refer to your system drawings
for circuit details.
If not Nordson USA ColorMax system:
Apply jumper to force On the remote disable input. Refer to
system drawings for jumper application.
No in/out positioner
response when Auto
mode selected
A fault has occurred
preventing Auto
operation.
Check iControl 2 alarm screen.
Identify the fault and correct. Review the related faults and
corrections listed in this table.
iControl 2 in/out
positioner configuration
settings have not been
completed.
Refer to
Network Configuration and In/Out Positioner
Configuration
in the iControl 2 Operator Interface manual. Make
sure all required settings have been made and are correct.
Refer to the in/out positioner/reciprocator control panel drawings
and make sure all connections have been made correctly.
Continued...