Nordson Encore HD iControl 2, Installation, Troubleshooting, Repair

Page: 41 / 114

© 2022 Nordson Corporation
1609758-04
3-17 Installation
Analog Scanner Connections
See Figure 3-9. If the system includes in/out positioners or reciprocators, then an
analog scanner junction box is added to the part ID stand to house the analog scanner
controllers. The controllers are powered by the 24 Vdc power supply in the PEJB.
The analog scanners are mounted on the stand to detect the part width for positioners,
and height for reciprocators. The scanners must be mounted with the cable ends oriented
as shown. Connect the scanner cables (BSCE, BSCR, SCNR1) from the junction box to
the scanners as shown.
NOTE: Horizontal dual scanners must be mounted so that they do not see the conveyor.
If using a single horizontal scanner, the scanner controller must be programmed to
ignore the conveyor.
Maximum Emitter/Receiver Separation:
6 meters (20 ft) if scanner is less than 1.22 meters (4 ft) long
4.6 meters (15 ft) if scanner is greater than 1.22 meters (4 ft) long
SCNR1
BSCE-L
BSCR-L
PJ2 Ethernet
BSCE-R
BSCR-R
Analog
Scanner J-Box
PEJB
PD1
SCNR1
SCNR1
Analog
Scanner J-Box
PEJB
BSCE
BSCR
PJ2 Ethernet
PD1
SCNR1
Dual Horizontal Scanner Configuration Single Horizontal Scanner Configuration
Figure 3-9 System Wiring − In/Out Positioner Scanner Connections
Customer-Supplied Part ID System Connections
Refer to Table 3-3 on page 3-14. Use the part ID terminals on the PEJB to connect a
customer-supplied part ID system to the iControl 2 console. The eight inputs are used
based on the settings made in the Photoeye Configuration screen. Refer to the iControl
Operator Interface manual for configuration instructions.