Nordson AltaBlueA4TP, Customer Product Manual

Page: 86 / 276

LEDs on component keys
Operation
4-12
Part 1107600_03 2014 Nordson Corporation
Monitor Component Temperatures
You can check the actual temperature of each heated component—the tank
and each hose and gun—using the automatic scan mode or by manually
selecting and checking each component.
By default, the melter remains in the automatic scan mode except when:
The melter is placed into the setup mode
The setpoint temperature of all hoses and guns is set to zero degrees
A fault occurs
To check component temperatures using the automatic scan mode
1. When the ready LED is on, observe the LEDs on the component keys.
2. When the LED on the key that represents the desired component
group (tank, hose, or gun) turns on, observe the left display until it
indicates the position number of the specific component you want to
check.
3. When the position number of the desired component appears in the
left display, observe the right display to determine the component's
actual temperature.