Nordson AltaBlueA4TP, Customer Product Manual

Page: 24 / 276

Description
2-4
Part 1107600_03 2014 Nordson Corporation
Intended Use
AltaBlue melters are specifically designed to:
Melt and pump solid‐form hot melt materials that are engineered to be
liquified and extruded at temperatures below 204
C (400 F)
Be used with compatible hot melt hoses and guns that are
manufactured by Nordson Corporation
Be used in non‐explosive environments
Limitations of Use
Use AltaBlue melters only for the purpose for which they are designed.
AltaBlue melters should not be used:
to melt or pump polyurethane reactive hot melt materials or any other
material that creates a health or safety hazard when heated
in environments that will require the melter to be cleaned using a
water wash or spray
Modes of Operation
AltaBlue melters operate in the following modes:
Automatic scan —The melter automatically checks and displays the
current temperature of the tank, hoses, and guns to confirm that they are
within their pre‐defined temperature range. By default, the melter is
always in the automatic scan mode unless it is placed into another
operating mode.
Standby —The temperatures of the tank, hoses, and guns are reduced
down from their operating temperature (hereafter referred to as setpoint
temperature) by a pre‐set number of degrees.
Setup —The setup mode is used to configure melter control options and
features and to review stored operating data. To prevent unauthorized
changes to the melter's configuration, the melter can be
password‐protected.
Fault —The melter alerts the operator when an abnormal event occurs.