nord NORDAC START Series, User Manual, Page: 56 / 120

NORDAC START (SK 135E / SK 175E) – Users Manual for Motor Starters
56 BU 0135 en-4118
Connection to motor starter
1. Remove right-hand diagnostics glass (transparent
cable gland) of the RJ12 socket from the housing
cover, alternatively remove housing cover
(illustration on right)
WARNING: Electric shock possible from touching
conducting parts with device open!
2. Set DIP switch to
Master RS 485
at converter
(SK TIE4-RS485-RS232)
3. Connect control and parametrisation unit to
converter
4. Check that the 24 V DC voltage supply at the
motor starter is switched on.
5. Connect converter with connected control and
parametrisation unit to diagnostics socket.
After completing commissioning, the power supply must be switched off again and the device correctly
closed off again (casing cover, diagnostics caps and cable glands) in order to restore operating safety
and the IP protection class).
Information
Diagnostic cap tightening torque
The tightening torque for the transparent diagnostic caps (inspection glasses) is 2.5 Nm.
Information
Control with SK PAR-3H
In order to be able to control the motor starter with the ParameterBox (SK PAR-3H) (Start / Stop), it must be put
into ControlBox Mode beforehand.
Step Menu item Selection
1
Display
 
o.k.
2 1003 selection
 
ControlBox
 
o.k.
3 P0 back
 
o.k.
However, motor starter parametrisation can be carried out independently of the mode that has been selected.