Disconnect the charger’s AC plug from
the AC mains socket; then disconnect the
clamps. Reconnect the clamps with
correct polarity and plug the charger back
in at the AC mains socket.
Motorcycle 2A Charging Mode (Press
once):
In this mode, the unit charges the
battery at a lower rate of charge with the
maximum current output to approximately
2A and the LCD screen will display the
following (The upper digital display will
blink “2.0A” and the Motorcycle Icon
will flash. The lower digital display shows
the voltage of the connected battery. The
Clamp Icons, Arrow Icons and the Battery
Icon will light solid) :
Vehicle 6A Charging Mode (Press
twice):
In this mode, the unit charges the
battery at a higher rate of charge with the
maximum current output to approximately
6A and the LCD screen will display the
following (The upper digital display will
blink “6.0A” and the Vehicle Icon
will flash. The lower digital display shows
the voltage of the connected battery. The
Clamp Icons, Arrow Icons and the Battery
Icon will light solid):
When the charger is properly connected
to the battery and the charger is plugged
into a functioning AC mains socket, the
charger will be in Standby mode and the
LCD screen will display the following (The
lower digital display shows the voltage of
the connected battery. The Clamp Icons,
Arrow Icons and the Battery Icon will light
solid.), indicating the unit is ready to use:
Note:
If the charger’s battery clamps have a
bad connection or are disconnected
from the battery, the LCD screen will
display the following (The Clamp Icons
will flash and the empty Battery Icon
will light solid.), indicating the battery
clamps are not yet connected to the
battery:
If the charger’s battery clamps are
connected incorrectly with regard to
polarity, the LCD screen will show the
following (The Fault Icon and “+” and
“–” inside the Battery Icon will flash.
The Clamp Icons and the empty
Battery Icon will light solid) and a
Warning will continuously sound until
the clamps are disconnected:
UTILISATION
D. Charging the battery using the
battery clamps .
1. When the charger is properly
connected, cycle through to
choose the following operation
mode by pressing the Charging
Mode Selector Button
14
4
