Nokia IP100 Series, Installation Manual

Page: 70 / 106

Using Boot Manager
56 IP100 Series Installation Guide
Protecting the Boot Manager With a Password
To prevent accidental or unauthorized access to the hard disk on your
IP100 Series NAP, you can require that the user enter a password to
access the
install
command in boot manager. Use the
passwd
command to set the password.
NOTE:
The password you enter here is the password that gives
you access to the
install
command in boot manager, not
access to IPSO.
To set a password, perform the following steps:
1.
At the boot manager command prompt, enter the following:
BOOTMGR[0]> passwd
The
passwd
program asks you for your current password.
2.
If the NAP is protected by a password, enter your current password.
3.
The program asks you for the new password. Enter the new
password..
4.
The program asks you to re-enter the new password for verification.
Enter the new password again.