Nokia IP100 Series, Installation Manual

Page: 29 / 106

IP100 Series Installation Guide 15
Placement of IP100 Series NAP
5.
Insert an anchor into each hole. Then place a standoff on the end of
each screw. Turn the screw so that the screw protrudes one quarter
inch from the wall.
6.
Hold the NAP so that the screws are in the center of the keyholes.
Push down on the NAP so each screw is lodged firmly into the top of
each keyhole slot.
You can re-orient the face plate so it reads from left to right when facing
the wall-mounted NAP (rather than being upside down). To do this, use
the following procedures:
1.
Pull the face plate off the unit. The face place is attached with
adhesive.
2.
Rotate the face plate 180 degrees
3.
Place the face plate back on the unit. Press firmly so it sticks to the
unit.
NOTE:
The adhesive on the back of the face plate will form a
permanent bond between the face plate and the unit approximately
four months from the date on which the face plate is initially
attached to the unit. After this point it will be impossible to re-orient
the face plate.