Nogueira FTN-1900, Instruction Manual

Page: 168 / 280

28
Instructions Manual
3. Presentation
Available versions:
With gearbox and hydraulic outlet chute
- PTO transmission to the rotor
by cardan shaft - deflector and outlet chute rotation driven by hydraulic cylinder.
The choice of tractor must take into account the hydraulic system lifting capacity
and the power required by the machine. It is recommended to use a category 2
tractor, with power from 90 to 130 hp in the power take-off (540 rpm), double
clutch with independent drive (PTO and engine).
The correct ratio between tractor size and machine weight ensures safety
during braking and maneuvering. The load lifted must not exceed the maximum
authorized load indicated in the tractor manual used (see machine weight under
'Technical Characteristics').
3.3- Functioning
3.4- Required Tractor
HARVESTING:
The harvester is coupled to the tractor through the three-point hydraulic lift
system and driven through the power take-off. As you progress through the
crop, knives mounted on the four front drums cut through the plants that are
in the working range of the head. The plants are gathered by the drums to
the platform, where two front feeding drums collect and two rear rollers lead
them to the chopper rotor.
PROCESSING:
The harvested plants are led by the rollers against the rotor, whose knives
simultaneously chopp and launch the forage through a outlet chute.
The chop size is defined by the number of rotor knives and/or by the speed
of the feed rollers, changed by exchanging a pair of gears of the transmission
that move the rollers.
DISCHARGE:
The forage launched by the rotors is driven through a outlet chute and directed
by a deflector (jet breaker) into a forage wagon that travels coupled to the
harvester.
ITEM CODE DESCRIPTION QTY
1 02.093645 Tool box 1
2 03.048642 Cutting gear 3mm 2
3 02.048652 Cutting Gear 5mm 2
4 03.048682 Cutting Gear 14mm 2
5 03.048692 Cutting Gear 18 mm 2
6 02.045001 Safety Pin 10
7 02.700182 Handle of the inverter tool 1
8 02.700181 Profile of the inverter tool 1
9 05.001475 Spring Pin 05 x 55 mm 4
10 05.001465 Spring Pin 08 x 55 mm 4
11 02.045003 Special Safety Pin 10
12 02.045091 Pin Punch 2
13 02.048735 Sharpener’s Handle 2